- Leave gun filled with foam after use.Always keep a filled can of gun foam on the gun.
- Tighten the flow adjustment screw completely.Do not empty the gun.Gun must always be filled with foam,otherwise foam is cured due to the humidity in the air.
- Put can away in a vertical position(gun upwards).
Use foam gun again
- Shake the can vigorously(keep hold of the gun).
- Remove cured foam at the tip of the nozzle carefully with a small,sharp knife.
- Release the flow adjustment screw lightly and dispense foam immediately until the flow of foam is correct.
- The gun is now ready to use.
- Foam output can be controlled with trigger of the gun.
Replacing of the can gun foam
- Check if the can is empty by dispensing foam in a dust-bin until no more foam is released.
- Take a new can of gun foam.Shake vigorously.
- Unscrew the empty can(keep valve opening away from you),remove released foam from adapter and replace the empty can immediately by a new one.
- Dispense foam immediately to fill the extension tube.
Cleaning of the foam gun at times of interruption
- Unscrew the can of gun foam (keep valve opening away from you).
- Take a can gun cleaner and screw the can on the gun.
- Pull the trigger again to refill the gun with cleaner.
- Cleaner has to remain in the gun for about 5 minutes.
- Pull the trigger again to refill the gun with cleaner.
- Unscrew the can gun cleaner.
- Screw the can gun foam onto the gun.
- Pull trigger of the gun again until foam is released and cleaner completely removed.
- The gun is now ready to use.